Aluminum Troche Molds
This two-piece mold can produce up to 100 troches. The mold consists of a solid base plate and a top plate with holes. Made of hard anodized aluminum, it has a coated surface for easy release of the finished product. The plates are held together with stainless steel screws and Heli-Coil screw thread inserts that resist wear over time, assuring a tight seal for years to come. Each cavity holds approximately 725 mg Polyethylene Glycol 1450, although the mold should be calibrated with the specific base being used. Clean with mild soap and hot water. Dishwasher safe with water only.
Individual cavities measure .5 x .2 in. /12.7 x 5 mm (Ø x D).Overall size 12.5 x 6 x .6 in. / 31.6 x 15.2 x 1.4 cm.